non woven abrasive  molding method according to the needs of different commonly used are the following :
A hydraulic molding hydraulic molding equipment hydraulic machines and hydraulic press , because oil has the proper viscosity, not prone to back and stable, so abrasive molding is generally used hydraulic machine without water presses, such as the use of appropriate structural hydraulic machine can have ease of lift . Allows ease of lifting the molding compound at the time of pressing the abrasive gases sufficient time to escape from the mold compound, and the material layer can have time to get up and down and reduce the wheel traverse uneven density , and reduced after moving the elastic effect, increasing the pressure to maintain a predetermined time to obtain better results ; this operation , but the lift is too slow , reducing productivity. Using high pressure into the 70s can get a higher density of the last century, the country has rough ring automatic molding machine, but it only applies to a single large production specifications , the SMEs do not apply.
The former Soviet Union had given automatic machine design thinking in a certain data, the agency is turning its schematic .
Its automatic machine with high pressure blower vacuum adsorption molding blank robot , some domestic plants are imitation of this robot moves rough , eliminating the flap procedure ( Figure 5 ) . In recent years, domestic research on automatic molding machine has made significant progress in Figure 6 is the factory producing ceramic abrasive 18- station automatic molding machine.