2013-01-13 by seoer10
Must correct selection and use of abrasive polishing glass edge polishing process. First to use glass edging machine types and models to determine the selection of the type of abrasive polishing. The same type of milling machine, polishing abrasive polishing effect and life will vary due to the good or bad quality, the level of accuracy. Secondly, you want to check whether the diamond rough grinding wheel and fine grinding wheel used to select the appropriate. If coarse diamond size diamond coarse grinding wheel and Abode grinding wheel, abrasive polishing difficult to diamond grinding wheel grinding traces completely throw away, it will affect the polishing abrasive consumption, reduce its life. Third, according to the glass edge processing requirements, brightness requirements, to select the applicable suitable abrasive polishing, in order to achieve that meet the processing requirements, reduce production costs, improve production efficiency,
standard abrasives, but also play a role. Finally, to comply with the norms of grinding and polishing, polishing abrasive prior to installation should be carefully examined whether there was a schism; installation, the application of a diameter not less than the polishing abrasive one-third of the diameter flange fastening; polishing abrasive use speed shall not exceed the provisions of the linear velocity of the security work; than dedicated to the end face of the abrasive polishing, abrasive end face work is prohibited; cooling water flow should be sufficient; operate in accordance with safety procedures Edger, select the appropriate head The length of the working pressure and the glass and the traveling speed; the abrasive polishing during storage should prevent cold and damp,
cut off wheel and should not be in contact with the bases, otherwise it will affect the strength of abrasive polishing and polishing.
2013-07-25 by seoer3
Abrasive sand paper called A material for polishing, in the original paper from sticking various abrasive grit. The ring of the product
Sandpaper on the application of environmental requirements for the paper is a paper tough, wear-resistant folding, and good water resistance, glass sand, etc.
Abrasive materials such as gum adhesive with adhesive on paper, after drying. Generally speaking, sandpaper commonly used to grind metal,
Wood and other surfaces to clean smooth it.
Sandpaper production techniques are generally divided into two categories, the first one: mechanical polishing, glass polishing wheel fitted with a polishing machine,
Dipped in glass polishing powder on the glass surface polishing, polishing the same operation process with other. The second: Chemical polishing: Use of
Learn liquid on the glass surface is polished, the operation process, there are two, soak the piece of glass cell method that is soaked in a liquid
Pool 2 to 3 hours and finally cleaned, polished and simultaneously on both sides for a glass immersion method or a glass-sided polished surface is not sticky
Protective film, the edge with adhesive tape from a block waterside, flat glass after glass surface of the liquid down in the depth of not less than 3 mm
M and as uniform as possible, 2 to 3 hours to finally clean.
Among them, the water mill sandpaper sandpaper, it's a smaller gap between the sand, very fine grind is also smaller, and with water
Fines will use flowing out, so to use with water, take water sandpaper dry grinding mince words will remain in the sand
Gap, so that the surface becomes light sandpaper to reach its present some effect, but not so troublesome dry sandpaper.
Russian
